10/29/2023 Which cisco ios switch command is used to configure the use of lacp on an interface?Read Now![]() ![]() This is also true when using VTP on the switches and in that case, even if inter-VLAN routing is not required. Trunk links are required between devices in any situation where traffic from multiple VLANs will traverse the link. ![]() The syntax of the command is as follows: Switch(config-if)# switchport mode trunk The switchport mode trunk command is used on the Cisco Catalyst 2950 switch to configure a port as a VLAN trunk port.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |